KAA31474AAB_SUR
KAA31474AAB_SUR
1. SCOPE 4
2 DEFINITIONS AND ACRONYMS 4
3 SAFETY REFERENCES 5
4 BEFORE THE INSTALLATION 5
4.1 SC Encoder 5
4.2 Power Supply and Ratings 5
4.3 RS Board Interface Description 6
4.4 Electromagnetic Noise and Interference 6
5 CONNECTIONS 7
5.1 Main Power Input (P1) 7
5.2 Motor & SC Encoder (P8 and P10) 7
5.3 Service Tool and OMU (P11 and P9) 7
5.4 Controller Interface 7
5.4.1 The 3-Wire Bit-coded Interface 8
5.4.2 Multidrop Serial Interface 9
5.4.3 CAN-Bus Interface 10
5.4.4 Discrete NSAA 11
6 FIRST INSTALLATION 13
6.1 Starting Up Condition 13
6.2 SETUP Routine (Basic Installation) 14
6.2.1 Configure parameters for door operator 14
6.2.2 Automatic Basic Setup for the Profiles 16
6.2.3 Setup for the profile set 17
6.3 Customer Specific Fine-tuning 17
7 CONTROLLER INSTALLATION 20
7.1 Discrete 3-Wire Interface 20
7.2 Multidrop Interface 20
7.3 CAN Interface 20
7.4 Discrete NSAA Interface 20
OTIS
Engineering Center
Korea
Software Basic Data
Start Up Routine
NGSOK2
No: KAA31474AAB_SUR
SCN: KAA31474AAB
Page: 3 / 43
Date: 2012-07-23
8 SOFTWARE UPGRADE VIA OMU 21
8.1 Check the safety conditions 21
8.2 Access to SPMDCB2: Top of car 22
8.3 Connect OMU to SPMDCB2 23
8.4 Prepare SPMDCB2 for upgrade 23
8.5 Upgrade 24
8.6 Disconnect OMU 25
8.7 Function Test 26
8.8 OMU menu structures 27
8.8.1 Main Menu 27
8.8.2 Upgrade 28
8.8.3 Restore 29
8.8.4 SW Info 30
8.8.5 Manual Command 31
9 PARAMETER DESCRIPTION 37
9.1 Profile 1 Parameters 37
9.1.1 Open parameters 37
9.1.2 Close parameters 38
9.1.3 Reopen parameters 39
9.1.4 Control Gain parameters 39
9.2 Profile 2 Parameters 40
9.3 Profile 3 Parameters 40
9.4 Profile 4 Parameters 40
9.5 Fireman SVC Phase 2 Profile Parameters 40
9.6 System parameters 40
9.7 Control parameters
- 上一篇:LCB_II 地址 2020/3/14
- 下一篇:KAA31474AAB_STM 2020/3/14